Dinobell Antenna Solutions
Contact
EnglishDutchFrenchItalianPortugueseRussianSpanish

Electrically short antennas

» Knowledge » Electrically short antennas

Electrically short antennas

February 4, 2019

It is possible to use simple impedance matching techniques to allow the use of monopole or dipole antennas substantially shorter than the ​1⁄4 or ​1⁄2 wavelength, respectively, at which they are resonant. As these antennas are made shorter (for a given frequency) their impedance becomes dominated by a series capacitive (negative) reactance; by adding an appropriate size “loading coil” – a series inductance with equal and opposite (positive) reactance – the antenna’s capacitive reactance may be cancelled leaving only a pure resistance. Sometimes the resulting (lower) electrical resonant frequency of such a system (antenna plus matching network) is described using the concept of electrical length, so an antenna used at a lower frequency than its resonant frequency is called an electrically short antenna.

 

For example, at 30 MHz (10 m wavelength) a true resonant ​1⁄4 wavelength monopole would be almost 2.5 meters long, and using an antenna only 1.5 meters tall would require the addition of a loading coil. Then it may be said that the coil has lengthened the antenna to achieve an electrical length of 2.5 meters. However, the resulting resistive impedance achieved will be quite a bit lower than that of a true ​1⁄4 wave (resonant) monopole, often requiring further impedance matching (a transformer) to the desired transmission line. For ever shorter antennas (requiring greater “electrical lengthening”) the radiation resistance plummets (approximately according to the square of the antenna length), so that the mismatch due to a net reactance away from the electrical resonance worsens. Or one could as well say that the equivalent resonant circuit of the antenna system has a higher Q factor and thus a reduced bandwidth, which can even become inadequate for the transmitted signal’s spectrum. Resistive losses due to the loading coil, relative to the decreased radiation resistance, entail a reduced electrical efficiency, which can be of great concern for a transmitting antenna, but bandwidth is the major facto that sets the size of antennas at 1 MHz and lower frequencies.

 

[from wikipedia]

Maybe you like also